Dt swiss tension manual

 · This is the usage manual for the DT Swiss Spoke Tensiometer. Reproduced with permission of DT Swiss. Document includes German, French and English.  · The deflection t is related to tension but not in a simple fashion. Nothing is particularly close the CX-Ray spokes so I chose a DT aerolite coated 02,0/2,3x0,9 mm on page 27 of the DT Swiss Tensio 2 User Manual. The results of the comparison are shown in the following plot. The horizontal axis is the load cell value, the vertical axis is. A spoke tension chart / tension conversion table for the famous Park Tool's TM1 tension meter. Here I would like to advise caution, as according to DT Swiss technical support, spokes from different manufacturers behave differently and so it is inadvisable to use spoke tension charts across different spoke makers carelessly. Meaning spoke.

The deflection t is related to tension but not in a simple fashion. Nothing is particularly close the CX-Ray spokes so I chose a DT aerolite coated 02,0/2,3x0,9 mm on page 27 of the DT Swiss Tensio 2 User Manual. The results of the comparison are shown in the following plot. The horizontal axis is the load cell value, the vertical axis is. 2. In order to avoid full detensioning of the spoke, the Spoke tension on asymmetrically spoked wheels on the low tension side should reach min. 80 kg. On symmetrically spoked wheels the spoke tension should minimum have kg. 3. We as spoke manufacturers like high spoke tensions. www.doorway.ru high spoke tension can damage the flange of the hub or. Rear shocks which have to be checked, can be sent postage paid to a DT Swiss Service Centre. Legal venue and place of performance is Biel (Switzerland). Swiss law shall apply. Subject to technical changes. Please keep the user manual and warranty for future use. Have a lot of fun with your DT Swiss rear shock! IMPORTANT!

A spoke tension chart / tension conversion table for the famous Park Tool's TM1 tension meter. Here I would like to advise caution, as according to DT Swiss technical support, spokes from different manufacturers behave differently and so it is inadvisable to use spoke tension charts across different spoke makers carelessly. Meaning spoke. •Spoke tension can be measured correctly by DT Swiss Tensio meter. •General tension standard: (Refer to WheelSystem spoke tension table for specific tension value of each wheel) •Front: N ~ N •Rear: N ~ N •Wheel should be distressing times during building wheel. The backside provides a list of the DT Swiss service centers. A list of all DT Swiss service centers can be found at www.doorway.ru This manual is intended for being printed as an A5 book let. Only print this manual if electronic usage is not possible. DT Swiss Manual Concept The DT Swiss manuals are split into the following types of manuals.